Replacing Seals and Bearings on Xylem Bell and Gossett VSX Double Suction Pump
Printer Friendly (PDF)
The Xylem Bell and Gossett VSX Double Suction Pump Series was designed for efficiency and ease of maintenance. In this video, an R. L. Deppmann service expert takes you step-by-step through the process of replacing the seals and bearings on these large pumps.
Additional VSX Double Suction Pump Repair Resources:
To supplement this video, you may want to review these additional resources:
- Bell and Gossett maintenance manual: This manual shows you how easy it is for one service technician to repair the pump.
- R. L. Deppmann’s October Service Tip of the Month: This post shows you how to disassemble the Bell and Gossett Xylem brand VSX Double Suction Pump.
- Bell and Gossett disassembly product video: This video, presented by B&G’s Little Red Schoolhouse series, is another look at the Xylem VSX Pump Disassembly process.
Categories
- Air & Dirt Control
- Air and dirt control
- Announcements
- Boilers
- Codes & Standards
- Codes and Standards
- Commissioning and balance
- Controls
- Cooling towers
- Electrical
- expansion & noise control
- Flow Measurement
- Flow Meters
- Glycol & Water Quality
- Glycol and Water Quality
- Heat Exchangers
- Humidifiers
- Hydronic Design
- Hydronic system design
- Affinity laws
- Air separators
- Chemical feed
- Chilled Water
- Cold water makeup
- Commissioning and balance
- Control valves
- Cooling
- Design Tools
- expansion & noise control
- Expansion/compression tank
- Expansion/compression tanks
- Heating
- Parallel pumping
- Pipe sizing
- Primary secondary
- Primary secondary piping
- Primary variable
- Primary variable piping
- Test and Balance
- Vibration
- Monday Morning Minutes
- Motors
- Plumbing System Design
- Plumbing systems
- Press
- Pressure gauges and thermometers
- Pumps
- Affinity laws
- Balancing
- Chilled Water
- Commisioning and balance
- Commissioning and balance
- Condensate
- Constant speed
- Cooling Towers
- Domestic water recirculation
- ECM
- Glycol
- Hot Water Recirculation
- Identification
- Installation
- Minimum flow
- NPSH
- Operation
- Parallel pumping
- Piping and Installation
- Pressure Boosters
- Primary Secondary
- Selection & Specification
- Selection and specification
- Speed
- Sump and Sewage
- Troubleshooting
- Variable Speed
- Service Tip of the Month
- Steam
- Steam system design
- Strainers
- Tanks
- Test and balance
- Troubleshooting
- Valves
- Variable Frequency Drives
- Variable Speed Drives
- Vibration
- Vibration and expansion control
- Water Heaters
- Water quality