Norm Hall
/
April 18, 2016
One of the most misunderstood items in the heat exchanger schedule is the fouling factor. This week’s Monday Morning Minutes post explores heat exchanger fouling factors... READ MORE
Printer Friendly (PDF)
Categories
- Air & Dirt Control
- Air and dirt control
- Announcements
- Boilers
- Codes & Standards
- Codes and Standards
- Commissioning and balance
- Controls
- Cooling towers
- Electrical
- expansion & noise control
- Flow Measurement
- Flow Meters
- Glycol & Water Quality
- Glycol and Water Quality
- Heat Exchangers
- Humidifiers
- Hydronic Design
- Hydronic system design
- Affinity laws
- Air separators
- Chemical feed
- Chilled Water
- Cold water makeup
- Commissioning and balance
- Control valves
- Cooling
- Design Tools
- expansion & noise control
- Expansion/compression tank
- Expansion/compression tanks
- Heating
- Parallel pumping
- Pipe sizing
- Primary secondary
- Primary secondary piping
- Primary variable
- Primary variable piping
- Test and Balance
- Vibration
- Monday Morning Minutes
- Motors
- Plumbing System Design
- Plumbing systems
- Press
- Pressure gauges and thermometers
- Pumps
- Affinity laws
- Balancing
- Chilled Water
- Commisioning and balance
- Commissioning and balance
- Condensate
- Constant speed
- Cooling Towers
- Domestic water recirculation
- ECM
- Glycol
- Hot Water Recirculation
- Identification
- Installation
- Minimum flow
- NPSH
- Operation
- Parallel pumping
- Piping and Installation
- Pressure Boosters
- Primary Secondary
- Selection & Specification
- Selection and specification
- Speed
- Sump and Sewage
- Troubleshooting
- Variable Speed
- Service Tip of the Month
- Steam
- Steam system design
- Strainers
- Tanks
- Test and balance
- Troubleshooting
- Valves
- Variable Frequency Drives
- Variable Speed Drives
- Vibration
- Vibration and expansion control
- Water Heaters
- Water quality