In part 1 and part 2 of this series, we discussed maximum and minimum heated water velocities in Bell & Gossett SU heat exchangers with standard... READ MORE
Printer Friendly (PDF)
Minimum Velocity in Heat Exchangers – Part 2
Norm Hall
/
May 2, 2016
Shell and Tube heat exchangers are often used in institutional steam-to-water heating applications. This week’s Monday Morning Minutes post looks at minimum velocities in Bell & Gossett... READ MORE
Printer Friendly (PDF)
Maximum Velocities in Heat Exchangers – Part 1
Norm Hall
/
April 25, 2016
Shell and Tube heat exchangers are often used in institutional steam-to-water heating applications. We recently received a call from a consulting engineer asking what the... READ MORE
Printer Friendly (PDF)
Categories
- Air & Dirt Control
- Air and dirt control
- Announcements
- Boilers
- Codes & Standards
- Codes and Standards
- Commissioning and balance
- Controls
- Cooling towers
- Electrical
- expansion & noise control
- Flow Measurement
- Flow Meters
- Glycol & Water Quality
- Glycol and Water Quality
- Heat Exchangers
- Humidifiers
- Hydronic Design
- Hydronic system design
- Affinity laws
- Air separators
- Chemical feed
- Chilled Water
- Cold water makeup
- Commissioning and balance
- Control valves
- Cooling
- Design Tools
- expansion & noise control
- Expansion/compression tank
- Expansion/compression tanks
- Heating
- Parallel pumping
- Pipe sizing
- Primary secondary
- Primary secondary piping
- Primary variable
- Primary variable piping
- Test and Balance
- Vibration
- Monday Morning Minutes
- Motors
- Plumbing System Design
- Plumbing systems
- Press
- Pressure gauges and thermometers
- Pumps
- Affinity laws
- Balancing
- Chilled Water
- Commisioning and balance
- Commissioning and balance
- Condensate
- Constant speed
- Cooling Towers
- Domestic water recirculation
- ECM
- Glycol
- Hot Water Recirculation
- Identification
- Installation
- Minimum flow
- NPSH
- Operation
- Parallel pumping
- Piping and Installation
- Pressure Boosters
- Primary Secondary
- Selection & Specification
- Selection and specification
- Speed
- Sump and Sewage
- Troubleshooting
- Variable Speed
- Service Tip of the Month
- Steam
- Steam system design
- Strainers
- Tanks
- Test and balance
- Troubleshooting
- Valves
- Variable Frequency Drives
- Variable Speed Drives
- Vibration
- Vibration and expansion control
- Water Heaters
- Water quality