Pump Training with Operation Engineers Local 324
Mark Fine presented to the Operating Engineers Local 324 at the Stationary Education Center & Apprenticeship on January 16, 2017. This training session covered basic pumping training consisting of Bell & Gossett pumps, pump curves, seals, the different pump types & system designs.
The attendees express appreciation for Mark’s inspiring presentation. Keith Smith, from Operating Engineers 324 stated “Mark’s years of experience, his depth of understanding, passion for the industry and his ability to present the subject in such an interesting way produced one of the most memorable presentation.”
The Operating Engineers Local 324 have the largest acreage training center located in Howell, Michigan. Their union is very excited to have partnered with Mark and the R.L. Deppmann Company.
Future R.L. Deppmann Seminars visit our training opportunities.
Categories
- Air & Dirt Control
- Air and dirt control
- Announcements
- Boilers
- Codes & Standards
- Codes and Standards
- Commissioning and balance
- Controls
- Cooling towers
- Electrical
- expansion & noise control
- Flow Measurement
- Flow Meters
- Glycol & Water Quality
- Glycol and Water Quality
- Heat Exchangers
- Humidifiers
- Hydronic Design
- Hydronic system design
- Affinity laws
- Air separators
- Chemical feed
- Chilled Water
- Cold water makeup
- Commissioning and balance
- Control valves
- Cooling
- Design Tools
- expansion & noise control
- Expansion/compression tank
- Expansion/compression tanks
- Heating
- Parallel pumping
- Pipe sizing
- Primary secondary
- Primary secondary piping
- Primary variable
- Primary variable piping
- Test and Balance
- Vibration
- Monday Morning Minutes
- Motors
- Plumbing System Design
- Plumbing systems
- Press
- Pressure gauges and thermometers
- Pumps
- Affinity laws
- Balancing
- Chilled Water
- Commisioning and balance
- Commissioning and balance
- Condensate
- Constant speed
- Cooling Towers
- Domestic water recirculation
- ECM
- Glycol
- Hot Water Recirculation
- Identification
- Installation
- Minimum flow
- NPSH
- Operation
- Parallel pumping
- Piping and Installation
- Pressure Boosters
- Primary Secondary
- Selection & Specification
- Selection and specification
- Speed
- Sump and Sewage
- Troubleshooting
- Variable Speed
- Service Tip of the Month
- Steam
- Steam system design
- Strainers
- Tanks
- Test and balance
- Troubleshooting
- Valves
- Variable Frequency Drives
- Variable Speed Drives
- Vibration
- Vibration and expansion control
- Water Heaters
- Water quality